Information
about the Fall
Cankerworm
2016

 

JackMcNeary.com
Comments, Facts, and Articles about
Environmental Issues, Ponds and Watergardens, Outdoor Interest

 Business Closing testing
 

Radio Tower for Short Wave or Commercial Use

This is a sectional galvanized steel radio tower made by Spaulding. The sections are 10 feet long and there are six of them.  With the Antenna on top this reaches about 70 feet.  We have it mounted in a cement base that is about four feet deep and four feet wide.  The tower can be unbolted from the base.

This is a self supporting tower and has four tapered sections and a top and bottom section.

We had one of our tree climbers some years ago install the tower, and he did it in a couple of hours.  If you buy it you get it as is and will have to remove it.  The antenna comes with the tower.  As a friend pointed out to me non stainless bolts were used to hold the tower together but my installer only used one per joint whereas there are four holes.  I mention that because that will make it easier to take down.

As you will note from the photographs, there are no guy wires to support the tower.  It is well made.

I will sell this tower for $700.00.

Contact me at 704-618-6214 or  jmcneary(removethis)@ gmail.com if you are interested in looking at this tower.

radio_tower 001

radio_tower-002

Contact me at 704-618-6214 or  jmcneary(removethis)@ gmail.com if you are interested in looking at this tower.

JackMcNeary.com
3521 Monroe Rd, Charlotte, NC 28205
Phone: 704.618-6214

comments powered by Disqus